PVDF Filament

We bieden 2 PVDF 3D filamenten:

  1. PVDF        monofilament 100% puur
  2. PVDF-C     co-polymeer

 

  • PVDF (PolyVinyliDeneFluoride) is beschikbaar in 1.75 en 2.85mm
  • PVDF-C is iets meer flexibel dan PVDF-H
  • PVDF-H heeft hoge krimp en is lastiger te printen
  • PVDF-C is zeer gemakkelijk te printen (bijna net als PLA)
  • PVDF-C zeer geschikt voor grote en/of massieve voorwerpen

TIP: supportmateriaal:

Je kunt zelfs PVDF printen met een supportmateriaal : HIPS. Het hecht niet aan PVDF, maar als je een dikke laag print ligt het PVDF op het HIPS. Veel klanten gebruiken het al.

 

Very easy to print without warping

Outstanding properties of our PVDF filament include:

  • Upper use temperature of 150 C
  • Long-term performance in direct contact with HCl, H2SO4, HF and HBr
  • UV resistant for years of sunlight without loss of mechanical properties
  • Low coefficient of friction for exceptional material release
  • Gamma ray sterilization without loss of tensile strength
  • Zero flame spread
  • Ion extraction at ppb levels
  • USP Class VI
  • Lot traceability

There are no perfect materials for every 3D printing application.  However,  Fluorinar™ filament will provide high-quality prints for prototypes, one-off prints or small production runs> These prints can be used in environments which exceed the capabilities of other 3D print materials. When you need Kynar® PVDF, nothing else will work.

Our PVDF filament is a low surface energy material so it does not adhere well to most surfaces.  Print adhesion can be tough to get unless you know one thing: Elmer’s disappearing purple glue stick.  Apply this adhesive evenly to a clean glass print surface.  Heat the printing bed to 100 C and extrude the Fluorinar™ filament at 240 – 260 C.  Print speed can be set between 10 – 40 mm/s.  Turn off the print surface cooling fans and get ready to see results as good as any other material available today. 

Unlike other advanced polymers, printing with Fluorinar™ filament can be done on consumer-grade equipment at a material price that won’t break the bank.  Contact us today and order a 500 g spool of Fluorinar™ or a filament test sample and get ready to expand your printing possibilities.

Customers in the USA and M- & South America can order here. It's easy and fast !

Door het gebruiken van onze website, ga je akkoord met het gebruik van cookies om onze website te verbeteren. Dit bericht verbergen Meer over cookies »