You can even print with a supportmaterial: HIPS.
There is no adhesion between the two, but you can print a thick roof on the HIPS and then lay the PVDF filament down on this.
Customers get great results doing this.
Outstanding properties of our PVDF filament include:
There are no perfect materials for every 3D printing application. However, Fluorinar™ filament will provide high-quality prints for prototypes, one-off prints or small production runs> These prints can be used in environments which exceed the capabilities of other 3D print materials. When you need Kynar® PVDF, nothing else will work.
Our PVDF filament is a low surface energy material so it does not adhere well to most surfaces. Print adhesion can be tough to get unless you know one thing: Elmer’s disappearing purple glue stick. Apply this adhesive evenly to a clean glass print surface. Heat the printing bed to 100 C and extrude the Fluorinar™ filament at 240 – 260 C. Print speed can be set between 10 – 40 mm/s. Turn off the print surface cooling fans and get ready to see results as good as any other material available today.
Unlike other advanced polymers, printing with Fluorinar™ filament can be done on consumer-grade equipment at a material price that won’t break the bank. Contact us today and order a 500 g spool of Fluorinar™ or a filament test sample and get ready to expand your printing possibilities.
Customers in the USA and M- & South America can order here. It's easy and fast !
With our partners at Nile Polymers.